Airlink101 802.11g Wireless Router AR315W Uživatelský manuál stáhnout pdf (Strana 9)

Section 4

Connecting to the Router Wirelessly

Below are the default wireless settings of the router. You must configure your wireless network card to the

same settings in order to establish a wireless connection with the router. Please refer to your wireless

network card’s manual for configuring these settings.

SSID: default

Operating Mode: Infrastructure

Channel #: 11

WEP: disabled

You may need to restart your computer after establishing a signal strength/link quality with the router.

Step 1 Power off the Cable/DSL modem, router, and computer and wait for 5 minutes.

Step 2 Turn on the Cable/DSL modem and wait for the lights on the modem to settle down.

Step 3 Turn on the router and wait for the lights on the router to settle down.

Step 4 Turn on the computer.

Step 5 Redo the Setup Wizard.

Step 6 Verify the Internet Connection Test is successful.

Section 5

Troubleshooting

If the Internet Connection Test fails, try the following steps:

If you can ping the router but cannot access the router’s web configuration page, try the

following steps:

For Windows 9x/ME/2000

Step 1 Go to Start, Settings, Control Panel, Internet Options.

Step 2 Select the Connections tab and click the Setup button.

Step 3 Select “I want to set up my Internet connection manually, or I want to connect through a

local area network (LAN)” and click Next.

Step 4 Select “I connect through a local area network (LAN)” and click Next.

1 2 3 4 5 6 7 8 9 10 11

Žádné komentáře

Airlink101 802.11g Wireless Router AR315W Uživatelský manuál Strana 9